General Information (Engine Electrical System): Specifications
Ignition System
IGNITION SYSTEM SPECIFICATION CHART
| Items | Specification | ||
|---|---|---|---|
| Ignition coil | Primary resistance | 0.62 ± 10 % (Ω) | |
| Secondary resistance | 7.0 ± 15 % (kΩ) | ||
| Spark plugs | Unleaded | NGK | IFR5G-11 |
| Gap | 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.) | ||
Starting System
STARTING SYSTEM SPECIFICATION CHART
| Items | Specification | ||
|---|---|---|---|
| Starter | Rated voltage | 12 V, 1.4 kW | |
| No. of pinion teeth | 8 | ||
| No-load characteristics | Voltage | 11.5 V | |
| Ampere | 85A, MAX | ||
| Speed | 2,600 RPM, MIN | ||
Charging System
CHARGING SYSTEM SPECIFICATION CHART
| Items | Specification | ||
|---|---|---|---|
| 3.3L | 3.8L | ||
| Alternator | Type | Battery voltage sensing | |
| Rated voltage | 13.5V, 130A A | ||
| Speed in use | 1,000 ~ 18,000 RPM | ||
| Voltage regulator | IC regulator built-in type | ||
| Regulator setting voltage | 4.2 ~ 14.8V | ||
| Temperature compensation | -4 ± 4 mV/°C | ||
| Battery | Type | 54 - 26 GL | 64 - 28 FL |
| Cold cranking amperage [at -18°C(-0.4°F)] | 600 A | 630 A | |
| Reserve capacity | 110 min | 130 min | |
| Specific gravity [at 20°C (68°F)] | 1.280 ± 0.01 | ||
NOTE:
- COLD CRANKING AMPERAGE is the amperage a battery can deliver for 30 seconds and maintain a terminal voltage of 7.2V or greater at a specified temperature.
- RESERVE CAPACITY RATING is amount of time a battery can deliver 25A and maintain a minimum terminal voltage of 10.5V at 26.7°C (80.1°F).
Auto Cruise Control System
AUTO CRUISE CONTROL SYSTEM SPECIFICATION CHART
| Items | Specification |
|---|---|
| Setting error | Within ± 1.5Km/h on level road |
| Vehicle speed memory variation | No variation |
| Setting time | 0.1sec max |
| Resuming time | 0.1sec max. |
| Minimum operating speed | 40 ± 2Km/h |
| Cancel speed range | 15 ± 2Km/h |
| Maximum memorized speed | 160 ± 2Km/h |
| Pulling force | 127N (13Kgf) |
| Main switch serial resistance value | 3.9kΩ ± 1% |
| Command switch serial resistance value | SET switch : 220Ω ± 1% |
| RESUME switch : 910Ω ± 1% |