Repair procedures: Installation

Installation is the reverse of removal.
CAUTION:
After replacement or reinstallation procedure of the automatic transaxle assembly, must perform procedures below.
- Power steering fluid replacement and air bleeding (Refer to GENERAL INFORMATION (STEERING SYSTEM) in ST group.)
- Adding automatic transaxle fluid. (Refer to Repair procedures in this group.)
NOTE:
- When replacing the automatic transaxle, reset the automatic transaxle's values by using the GDS.
- - IG Key On
- - Transaxle Range:P
- - Vehicle Speed :0 km/h
- - Engine Off
  
  Fig 1: Resetting Automatic Transaxle Values
  Courtesy of HYUNDAI MOTOR CO.
  
  Fig 2: Verifying Conditions For Resetting
  Courtesy of HYUNDAI MOTOR CO.
  
  Fig 3: Resetting Procedure Completed
  Courtesy of HYUNDAI MOTOR CO.