Repair Procedures: Installation
CAUTION:
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer to TEACHING PROCEDURES )
[In the case of installing used ECM]
- Perform "ECM Neutral mode" procedure with GDS. (Refer to NEUTRALIZING OF ECM in IMMOBILIZER SYSTEM article )
- After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to TEACHING PROCEDURES )
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer to TEACHING PROCEDURES )
- Installation is reverse of removal.
ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
ECM bracket installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)