Control Cable Assembly Replacement

Remove the center console.
(Refer to "interior (CONSOLE )" )
Remove the control cable (B).

Fig 1: Identifying Control Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the retainer (A) and nuts (B).
Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

Fig 2: Identifying Retainer And Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the nut (A) from the manual control lever.
Remove the control cable (B) from the bracket (C) at transaxle assembly side.
(Refer to "AUTOMATIC TRANSAXLE " )

Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

Fig 3: Identifying Control Cable, Bracket And Manual Control Lever Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the control cable at cabin room.
Installation is the reverse of removal.
NOTE:
- Set room side AT lever (shift lever) and automatic transaxle side manual control lever to "N" position.
- Control cable must be free unreasonable bending.