Fuel Injector Control Module: Service and Repair

Removal

1. Turn the ignition switch off and disconnect the battery negative (-) cable.
2. Disconnect the injector drive box (IDB) connector (A).




3. Remove the air cleaner assembly.
4. Remove the main wiring harness (B) after removing the nut (A).




5. Remove the IDB bracket assembly (B) after removing the bolts (A).




6. After removing the installation bolts (A), remove the IDB from the bracket.






Installation

1. Installation is the reverse of removal.

IDB installation bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
IDB bracket installation bolt (on vehicle):
18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)