Front Fender: Service and Repair

Replacement

CAUTION:
- When removing and installing the fender, an assistant is necessary.
- Be careful not to damage the fender and body.
- When removing the clips, use a clip remover.

1. Remove the front bumper cover.

2. Remove the head lamps.

3. Loosen the mud guard (A) mounting screws and clips.




4. To remove the A pillar garnish (A), loosen the mounting screw after removing the cap (B).

Tightening torque :
0.5 - 1.0N.m (0.05 - 0.1kgf.m, 0.4 - 0.7 lb-ft)




5. Detach the clip and then remove the fender side cover (A).




6. Detach the clips and then remove the insulator pad (A).




7. After loosening the mounting screws and bolt, then remove the front bumper side mounting bracket (A).




8. After loosening the mounting bolts and nut, then remove the fender (A).




9. Installation is the reverse of removal.