Repair Procedures: Installation

Install the inhibitor switch. When installing, tighten the inhibitor assembly mounting bolts (A) lightly, so that necessary adjustments can be made.

Fig 1: Identifying Inhibitor Assembly Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking release lever (A).
Tighten the nut (B) to specifications.
Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Install the SST (09480-A3800) or 0.1969in. (5mm) bolt after setting parking release lever (A) in the "P".

Fig 2: Identifying Parking Release Lever
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the bolts (A) to specifications.
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 3: Identifying Parking Release Lever Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the SST (09480-A3800) or 0.1969in. (5mm) bolt.
Install the shift cable by tightening the nut (A) and tighten the nut to specification.
Connect the inhibitor switch connector (B).
Tightening torque:

12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

NOTE: Adjust the shift cable before tighten the nut.
(Refer to SHIFT CABLE .

Fig 4: Identifying Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Connect the negative (-) battery cable.