Repair Procedures: Replacement
NOTE:
When replacing the Transaxle Control Module (TCM), the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used TCM]
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
[In the case of installing used TCM]
- Perform "TCM neutralization mode" procedure with GDS.
- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
[In the case of installing new TCM]- Insert the key and turn it to the IGN ON and OFF position.
Then the TCM key register process is completed automatically.
- Turn ignition switch OFF.
- Disconnect the negative (-) battery cable.
- Disconnect the TCM connector (A).
- Remove the TCM (A) after removing the mounting bolts and nut.
TCM installation bolt/nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)