Inspection Procedure (Using the GDS)
- Turn OFF the ignition switch.
- Connect the GDS to the data link connector on the lower crash pad.
- Turn ON the ignition switch.
- Use the GDS to check the diagnostic trouble code.
- Repair the faulty part from the diagnosis chart.
- Erase the diagnostic trouble code.
- Disconnect the GDS.
CAUTION:
- Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "REPAIR PROCEDURES ")
- Adding automatic transaxle fluid.
(Refer to "FLUID ")
- After servicing the automatic transaxle or TCM, clear the diagnostic trouble code (DTC) using the GDS tool.
Diagnostic trouble codes (DTC) cannot be cleared by disconnecting the battery.