Repair procedures: Removal

Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
Remove the battery and the battery tray.
(Refer to "CHARGING SYSTEM ")
Remove the air cleaner assembly.
(Refer to "INTAKE MANIFOLD ")
Remove the shift cable mounting nut (B).
Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 Kgf.m, 5.7 ~ 8.6 lb-ft)
Disconnect the inhibitor switch connector (A).

Fig 1: Inhibitor Switch Connector And Shift Cable Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Remove the manual control lever (B) and the washer after removing a nut (A).

Fig 2: Manual Control Lever, Washer And Nut
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION:
When installing, affix the manual control lever and the inhibitor switch with Ø5mm (0.1969in.). Then tighten the inhibitor assembly mounting bolts.
Remove the inhibitor assembly (A) after removing the bolts (2ea).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 3: Inhibitor Switch Assembly

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION:

When installing, tighten the inhibitor assembly mounting bolt lightly, so that necessary adjustments can be made. Tighten to specifications.