Repair Procedures: Removal

Driver Power Window Switch 

1. Disconnect the negative (-) battery terminal.
2. Remove the front door trim panel.

   (Refer to "FRONT DOOR TRIM ")

3. Disconnect the power window switch module connector (A) from the wiring harness.
   Fig 1: Power Window Switch Module And Connector

   Courtesy of HYUNDAI MOTOR AMERICA
4. Remove the power window switch module (B) from the door trim after loosening the mounting screws.
   NOTE:

   • Be careful not to damage door trim panel and door module mounting hooks.

Passenger Power Window Switch 

1. Disconnect the negative (-) battery terminal.
2. Remove the front door trim panel.

   (Refer to "FRONT DOOR TRIM ")

3. Disconnect the connector from the power window switch module.
4. Remove the power window switch module (A) from the door trim after loosening the mounting screws.
   Fig 2: Power Window Switch Module

   Courtesy of HYUNDAI MOTOR AMERICA
5. Remove the power window switch after loosening screws.

Rear Power Window Switch 

1. Disconnect the negative (-) battery terminal.
2. Remove the rear door trim panel.

   (Refer to "REAR DOOR TRIM ")

3. Disconnect the connector (A) from the power window switch module.
4. Remove the power window switch module (B) from the door trim after loosening the mounting screws.
   Fig 3: Power Window Switch Module Connector

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 4: Power Window Switch Module

   Courtesy of HYUNDAI MOTOR AMERICA
5. Remove the power window switch (A) after loosening the fixing clip.
   Fig 5: Power Window Switch

   Courtesy of HYUNDAI MOTOR AMERICA