Repair procedures: Removal
WARNING:
- DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Disconnect the camshaft position sensor connector (A).
- Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.
[Bank 1/Intake]
Courtesy of HYUNDAI MOTOR AMERICA
[Bank 1/Exhaust]
Courtesy of HYUNDAI MOTOR AMERICA
[Bank 2/Intake]
Courtesy of HYUNDAI MOTOR AMERICA
[Bank 2/Exhaust]