LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2015 >> Azera Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System >> Injector >> Repair procedures >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Installation

Fig 1: Combustion Seal, Rubber Washer, Support Disc, O-Ring
G10367483Courtesy of HYUNDAI MOTOR AMERICA
  1. Combustion seal
  2. Rubber washer
  3. Support disc
  4. O-ring
    CAUTION:
    • Do not reuse the used injector fixing clip.
    CAUTION:
    • Install the component with the specified torques.
    • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
    CAUTION:
    • Apply engine oil to the injector O-ring.
    • Do not reuse the used injector O-ring.
    CAUTION:
    • Do not reuse the used bolt.
    CAUTION:
    • When inserting the injector, be careful not to damage the injector tip.
    CAUTION:
    • Do not reuse the support disc.
    • Do not reuse the injector rubber washer.
    • When replacing the rubber washer, the rounded edge (A) part should be faced the cylinder installation part and the angulated edge (B) part should be faced the injector body part.
    Fig 2: Injector Angulated And Rounded Edge
    G10367484Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • Do not reuse the combustion seal.
    1. Installation is reverse of removal.
scientia non olet · About LEMON Manuals