LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2015 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 1.6L T-GDI >> Camshaft Position Sensor (CMPS) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

WARNING:
  • DON'T remove the Camshaft Position Sensor while the Engine is running or right after Engine is turned OFF. The part and Engine Oil is HOT and can cause burns.

[Bank 1/Intake] 

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Camshaft Position Sensor Connector (A).
  3. Remove the Installation Bolt (B) and remove the Sensor.
Fig 1: Camshaft Position Sensor Connector And Installation Bolt (Bank 1/Intake) Location
G10604563Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Exhaust] 

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Camshaft Position Sensor Connector (A).
  3. Remove the Installation Bolt (B), and then remove the Sensor.
Fig 2: Camshaft Position Sensor Connector And Installation Bolt (Bank 1/Exhaust) Location
G10604564Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals