Repair procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the connector (A), and then remove the sensor (B).
NOTE: Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1/Sensor 1]

Fig 1: Connector (Bank 1/Sensor 1)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Sensor (Bank 1/Sensor 1)
Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Sensor 2]

Fig 3: Connector (Bank 1/Sensor 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 4: Sensor (Bank 1/Sensor 2)
Courtesy of HYUNDAI MOTOR AMERICA

[Bank 2/Sensor 1]

Fig 5: Connector (Bank 2/Sensor 1)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Sensor (Bank 2/Sensor 1)
Courtesy of HYUNDAI MOTOR AMERICA

[Bank 2/Sensor 2]

Fig 7: Connector (Bank 2/Sensor 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 8: Sensor (Bank 2/Sensor 2)
Courtesy of HYUNDAI MOTOR AMERICA