LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Equus Signature >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System >> Knock Sensor (KS) >> Repair procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold (Refer to "INTAKE & EXHAUST SYSTEM ").
  3. Disconnect the knock sensor connector (A).

    [Bank 1] 

    Fig 1: Knock Sensor Connector (Bank 1)
    G10382673Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 2] 

    Fig 2: Knock Sensor Connector (Bank 2)
    G10382674Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the cross over fuel pipe (A).
    Fig 3: Cross Over Fuel Pipe
    G10382675Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the installation bolt (A), and then remove the sensor from the cylinder block.
    Fig 4: Sensor And Cylinder Block Installation Bolt
    G10382676Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals