Blind Spot Detection System DTCS
BLIND SPOT DETECTION SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C110117 | Battery Voltage High |
| DTC C110216 | Battery Voltage Low |
| DTC C120A11 | LED Right Circuit Short to Ground |
| DTC C120B15 | LED Right Circuit Short to Battery or Open |
| DTC C120C11 | LED Left Circuit Short to Ground |
| DTC C120D15 | LED Left Circuit Short to Battery or Open |
| DTC C150101 | Switch Failure |
| DTC C160A88 | BSD Local CAN bus off |
| DTC C161187 | CAN Time-out EMS |
| DTC C161287 | CAN Time-out TCU |
| DTC C161381 | CAN signal error EMS |
| DTC C161688 | CAN Bus OFF (C-CAN) |
| DTC C162587 | CAN Time-out ABS/ESC (ESP) |
| DTC C162887 | CAN Time-out Cluster |
| DTC C164681 | CAN Message Failure - TCU |
| DTC C167100 | Signal Yaw Rate or Acceleration AX or Acceleration AY or Brake pressure State not valid |
| DTC C170255 | Variant Coding Error |
| DTC C170A11 | Activation Switch LED Circuit short to ground |
| DTC C170B12 | Activation Switch LED Circuit short to battery or open |
| DTC C170C04 | ECU Hardware error (REAR RIGHT) |
| DTC C170D04 | ECU Hardware error (REAR LEFT) |
| DTC C174305 | Software Mis-Match |
| DTC C181287 | CAN Time-out Gateway |
| DTC C270254 | Control Module Missing Calibration |
| DTC C270354 | Control Module Slave Missing Calibration |