Repair procedures: Installation

Install the inhibitor switch. When installing, tighten the inhibitor assembly mounting bolts (A) loosely to allow any necessary adjustments to be made.

Fig 1: Inhibitor Assembly Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install the manual control lever (A).
Tighten the nut (B) to the specified torque.
Tightening torque:

16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Install the SST (09480-A3800) or 0.1969in. (5mm) bolt after setting manual control lever (A) in the "N".

Fig 2: Installing SST (09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the bolts (A) to the specified torque.
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 3: Inhibitor Assembly Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the SST(09480-A3800) or 0.1969in. (5mm) bolt.
Install the shift cable and tighten the mounting nut (A).
Connect the inhibitor switch connector (B).
Tightening torque:

12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

NOTE: Adjust the shift cable before tightening the nut.
(Refer to "SHIFT CABLE ")

Fig 4: Inhibitor Switch Connector And Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Connect the negative (-) battery cable.