Repair Procedures: Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the connector (A), and then remove the sensor (B).
   NOTE: Note that the SST (Part No.: 09392-2H100) is useful when removing the heated oxygen sensor.
   Fig 1: Identifying SST (Part No.: 09392-2H100)

   Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Sensor 1] 

Fig 2: Identifying Connector (Bank 1/Sensor 1)

Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Identifying Sensor (Bank 1/Sensor 1)

Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Sensor 2] 

Fig 4: Identifying Connector (Bank 1/Sensor 2)

Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Identifying Sensor (Bank 1/Sensor 2)

Courtesy of HYUNDAI MOTOR AMERICA