Power Window Main Switch Inspection

Disconnect the Negative (-) Battery Terminal.
Remove the Front Door Trim Panel.
(Refer to: the BD procedure - "FRONT DOOR ").
Check for continuity between the Terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.

Fig 1: Removing Front Door Trim Panel
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Power Window Main Switch Terminal Continuity Chart (1 Of 3)
Courtesy of HYUNDAI MOTOR AMERICA

[Auto Down]

Fig 3: Power Window Main Switch Terminal Continuity Chart (Auto Down) (2 Of 3)
Courtesy of HYUNDAI MOTOR AMERICA

[Safety Up/Down]

Fig 4: Power Window Main Switch Terminal Continuity Chart (Safety Up/Down) (3 Of 3)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Grip Holder Cover after loosening 4 Bolts.

Fig 5: Grip Holder Cover Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Grip Holder Bracket (A).

Fig 6: Grip Holder Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Power Window Switch Module (A) after loosening 4 Screws.

Fig 7: Power Window Switch Module Screws
Courtesy of HYUNDAI MOTOR AMERICA