LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 1.6L GDI >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Release the residual pressure in Fuel Line (Refer to: "RELEASE RESIDUAL PRESSURE IN FUEL LINE " in this procedure).
    CAUTION: When removing the Fuel Pump Relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the Intake Manifold (Refer to: "Intake And Exhaust System" in EM procedure).
  4. Disconnect the Rail Pressure Sensor Connector (A), and then remove the Sensor (B) from the Delivery Pipe.
    Fig 1: Rail Pressure Sensor And Connector Location
    G10607957Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals