Initializing Method Of The Safety Power Window

When the battery is not connected the vehicle over the 5 minutes, safety power window switch need the initializing.

1. Power window operation before initializing
   • Manual-Up/Down function is available
   • Auto-Up function is not available

     (When holding the auto-up/down switch, window is operated as a manual-up/down.)

2. Initializing method

   Close the window in window open position, and holding the switch in window full close position over the 0.2 second.

   (If start the closing the window in window full close position, initializing could be failed.)

3. If initialize the safety power window in jamming status, could occur below conditions.
   • Safety function is not available

1. If the window moved by compulsion and motor have a problem, power window switch could be entering the fail safe mode for user's safety.
2. Power window operation in fail mode
   • Auto/Manual-Down function is available
   • Auto/Manual-Up function is not available

     (When auto/manual-up is operated, window is rising 20mm and is stopped the moving.)