Repair Procedures: Installation

CAUTION: When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]

Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
After finishing "ECM Neutral mode", perform TEACHING PROCEDURES with GDS.

(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
[In the case of installing new ECM]
Perform TEACHING PROCEDURES with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")

CAUTION: When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
[In the case of installing used ECM]

Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.

[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.

Installation is reverse of removal.
ECM installation nut:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lbf.ft)

ECM installation screw:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lbf.ft)

ECM bracket installation bolt/nut:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lbf.ft)