Repair Procedures: Replacement

Disconnect the negative (-) battery terminal.
Remove the crash pad lower panel.
(Refer to Body - "CRASH PAD ")
Remove the steering column upper & Lower shroud.
Remove the ignition switch (A) and disconnecting the Key Warning/immobilizer connector.

Fig 1: Ignition Switch
Courtesy of HYUNDAI MOTOR AMERICA
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.

Fig 2: Pushing Lock Pin
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Locating Key Lock Cylinder, Key Warning Switch And Ignition Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal procedure.