Repair Procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "AIR CLEANER ")
Disconnect the EWGA connector (A).

Fig 1: Locating EWGA Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the exhaust manifold heat protector.
(Refer to Engine Mechanical System - "EXHAUST MANIFOLD ")
Remove the shaft link assembly (B) after removing the C-ring (A).

Fig 2: Locating Shaft Link Assembly And C-Ring
Courtesy of HYUNDAI MOTOR AMERICA
Remove the turbo charger water pipe installation bolts (A).

Fig 3: Locating Turbo Charger Water Pipe Installation Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the EWGA after removing the bolts (A).

Fig 4: Locating EWGA Bolts

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When carrying the turbo charger, do not hold the rod of the turbo charge to prevent bending the rod.