Repair Procedures: Installation: Notes
NOTE:
When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Then the ECM key register process is completed automatically.
[In the case of installing used ECM]
- Perform "Neutral mode" procedure with GDS. (Refer to - "Neutralizing Of ECM
").
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ").
- Insert the key and turn it to the IGN ON and OFF position. Then the ECM key register process is completed automatically.
[In the case of installing new ECM]
- Insert the key and turn it to the IGN ON and OFF position.
Then the ECM key register process is completed automatically.
- Install in the reverse order of removal.
ECM installation nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
ECM bracket installation nut/bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)