Power Window Main Switch Inspection

Disconnect the negative (-) battery terminal.
Remove the front door trim panel.
(Refer to "FRONT DOOR ")
Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.

Fig 1: Removing Power Window Main Switch
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Power Window Main Switch Connector Terminals Continuity Chart
Courtesy of HYUNDAI MOTOR AMERICA

Auto Down

Fig 3: Power Window Main Switch Connector Terminals Continuity Chart (Auto Down)
Courtesy of HYUNDAI MOTOR AMERICA

Safety Up/Down

Fig 4: Power Window Main Switch Connector Terminals Continuity Chart (Safety Up/Down)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the grip holder cover after loosening 4 bolts.

Fig 5: Removing Grip Holder Cover Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the grip holder bracket (A).

Fig 6: Removing Grip Holder Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the power window switch module (A) after loosening 4 screws.

Fig 7: Removing Power Window Switch Module Screws

Courtesy of HYUNDAI MOTOR AMERICA