[In The Case Of Installing New ECM]
- Perform "TEACHING MODE PROCEDURE DESCRIPTION (STEP BY STEP)
" procedure with GDS.
(Refer to "IMMOBILIZER SYSTEM DIAGNOSIS (PHEV) ")
CAUTION:
- When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
- Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
- Install in the reverse order of removal.
ECM Installation nut:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
ECM Bracket installation bolt/nut:
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)