LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 1993 >> J30 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Computerized Engine Controls >> Engine Control Module (ECM) >> Power Circuits
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Circuits

  1. Ensure ignition switch is in OFF position. Using a voltmeter, check for battery voltage between chassis ground and ECM terminals No. 46 and 109 on G20, or ECM terminal No. 58 on all other models. See Figure or Figure . If battery voltage is not present, check fusible link and wiring. Fusible link also supplies power for fuel injectors.
  2. Turn ignition switch to ON position. Using a voltmeter, check for battery voltage between chassis ground and ECM terminals No. 36, 38 and 47 on G20 or terminals No. 45, 49, 59 and 109 on J30 and Q45. If battery voltage is not present, check fusible link and fuse "G". Turn ignition switch to OFF position. Battery voltage should be present for approximately 2-3 seconds at terminals No. 38 and 47 on G20 or terminals No. 49, 59 and 109 on J30 and Q45. If battery voltage is not as specified, check ECCS relay.
  3. Connect voltmeter between chassis ground and ECM terminal No. 34 on G20 or terminal No. 43 on J30 and Q45. Turn ignition switch to START position. Battery voltage should be present only when ignition switch is in START position. If voltage is not present, check for blown fuse and defective ignition switch.
scientia non olet · About LEMON Manuals