Ground Circuits
- Using an ohmmeter, check for continuity to ground on ECM terminals as follows:
- Terminals No. 10, 19, 25, 32, 43, 108, 116 and 124. See Figure .
Resistance should be zero ohms. If resistance is not zero ohms, repair open to ground.
- Using a DVOM, touch negative lead of voltmeter to a good ground. Using positive lead of voltmeter, backprobe each ground terminal at ECM connector. With vehicle running, voltmeter should indicate less than one volt. If voltmeter reading is greater than one volt, check for open, corrosion or loose connection on ground lead.