Fuel Injector Test
NOTE:
A fault in fuel injector circuit should set DTC P0170, DTC P0171, DTC P0172, DTC P0173, DTC P0174 or DTC P0175. To test system, see diagnostic procedures in appropriate TESTS W/CODES
article.
- Turn ignition off. Disconnect injector harness connectors. Turn ignition on. Measure voltage between ground and each injector harness connector White/Red wire. If battery voltage is not present, check Brown fusible link connected to positive battery post. If fusible link is okay, repair or replace harness or connectors.
- If battery voltage is present, check fuel injector. See FUEL INJECTOR. If injector is okay, check ECM terminals, harness, and connector terminals for damage or corrosion. Repair or replace as necessary.