Without Nissan CONSULT Scan Tool
- New identity (ID) code must be manually entered whenever replacing remote controller or BCM, or when adding additional remote controller(s). To enter ID code, perform steps 2 and 3 .
- Close all doors. Lock driver's door. Erase original ID codes by inserting and removing key from ignition switch more than 6 times within 10 seconds. Turn ignition switch to ACC position.
- Push any lock button on new remote controller once. ID code for new remote controller has now been entered.
- Repeat step 3 to enter additional remote controller ID codes. A maximum of 4 remote controller ID codes can be entered. If same ID code is entered more than once, the entry is ignored. To exit programming (ID entry) mode, open driver's side door and remove key from ignition switch.