Programming New Id Code

NOTE: This procedure will erase all previous identity codes and render all previously programmed remote controllers inoperative (until reprogrammed). All remote controllers to be used with system must be programmed at the same time.

NOTE: A maximum of 4 remote controllers can be programmed. Any attempt to program more than 4 controllers will be ignored. If same identity code is entered more than once, entry is ignored even though hazard warning lights will still flash twice.

Close and lock all doors. Erase original identity code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights should flash twice. Turn ignition switch to ACC position.
Push any button on new remote controller once. Hazard warning lights should flash twice, indicating ID code has been entered. If identity code cannot be entered, repair multi-remote system.
For each additional remote controller to be programmed, manually release door lock, and lock again by using door panel switch. Repeat step 2 . If no additional remote controllers are to be used, exit programming mode by unlocking and opening driver's door.