DTC Confirmation Test (Using CONSULT-II)
- Turn ignition on. Select P/N POSI SW in DATA MONITOR mode with CONSULT-II.
- Check P/N POSI SW signal under the following conditions.
- With transmission in Park or Neutral, ON should be displayed.
- With transmission not in Park or Neutral, OFF should be displayed.
If operation is as specified, go to next step. If operation is not as specified, go to appropriate DIAGNOSTIC PROCEDURE.
- Select DATA MONITOR mode with CONSULT-II. Start engine and warm to normal operating temperature.
- Maintain the following conditions for at least 50 consecutive seconds:
- ENG SPEED: more than 1400 RPM.
- COOLAN TEMP/S: more than 158°F (70°C).
- B/FUEL SCHDL: more than 2 msec.
- VHCL SPEED SE: more than 40 MPH.
If 1st trip DTC is detected, go to appropriate DIAGNOSTIC PROCEDURE. If 1st trip DTC is not detected, system is okay at this time.