Control Unit Input/Output Signal Standard: Notes
- (Note 1): When the parking brake is checked using a circuit tester for voltage measurement, the connector terminals should not extend forcefully.
- (Note 2): Check the pressure of the tire in normal condition.
- (Note 3): ON/OFF timing of the ABS warning lamp:
- ON: When the ignition switch is turned ON (before engine start) or a malfunction is detected.
- OFF: 2 seconds after the engine started (the system is in normal condition).
- (Note 4): VDC OFF indicator lamp ON/OFF timing
- ON: When the ignition switch is turned ON (before engine start) or a malfunction is detected, if the TCS OFF switch is ON.
- OFF: 2 seconds after the engine started (the system is in normal condition) and TCS OFF switch is OFF.
- (Note 5): ON/OFF timing of the SLIP indicator lamp.
- ON: When the ignition switch is turned ON (before engine start) or a malfunction is detected, if the VDC/TCS function is active during driving.
- OFF: 2 seconds after the engine started (the system is in normal condition) and the VDC/TCS function is inactive.
- Flashing: VDC/TCS function is active during driving.
- (Note 1): Check the pressure of the tire in normal condition.
- (Note 2): ON/OFF timing of the ABS warning lamp:
- ON: For approximately 0.5 seconds after the ignition switch is turned ON, or when a malfunction is detected.
- OFF: Approximately 0.5 seconds after the ignition switch is turned ON (when the system is in normal operation).
- (Note 3): ON/OFF timing of the VDC OFF indicator lamp:
- ON: For approximately 0.5 seconds after the ignition switch is turned ON, or when a malfunction is detected VDC OFF switch is ON.
- OFF: Approximately 0.5 seconds after the ignition switch is turned ON (when the system is in normal operation) or when VDC OFF switch is OFF.
- (Note 4): SLIP indicator lamp ON/OFF timing:
- ON: For approximately 0.5 seconds after the ignition switch is turned ON, or when a malfunction is detected VDC/TCS function is activated while driving.
- OFF: Approximately 0.5 seconds after the ignition switch is turned ON (when the system is in normal operation) or when VDC/TCS function is not activated.
- Flashing: VDC/TCS function is active during driving.