DTC Confirmation Procedure
NOTE:
If DTC confirmation procedure has been previously conducted, always turn ignition switch to OFF position and wait at least 10 seconds before conducting the next test.
- Turn ignition switch to ON position.
- Select DATA MONITOR mode using either CONSULT-II or GST.
- Check that COOLAN TEM/S is more than 50°F (10°C). If COOLAN TEM/S is more than 50°F (10°C), test results will be okay. If COOLAN TEM/S is not more than 50°F (10°C), go to next step.
- Start engine and run it for 65 minutes at idle speed. If COOLAN TEM/S increases to more than 50°F (10°C) within 65 minutes, stop engine because test result will be okay.
- If a DTC is detected, go to DIAGNOSTIC PROCEDURE . If DTC is not detected, system is okay at this time.