DTC Confirmation Procedure
NOTE:
If DTC confirmation procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
Using CONSULT-II Or GST
- Turn ignition switch to ON position.
- Select DATA MONITOR mode.
- Wait at least 10 seconds.
- Press and hold ON/OFF switch for at least 10 seconds, then release and wait at least 10 seconds.
- Press and hold ACCEL/RES switch for at least 10 seconds, then release and wait at least 10 seconds.
- Press and hold COAST/SET switch for at least 10 seconds, then release and wait at least 10 seconds.
- Press and hold CANCEL switch for at least 10 seconds, then release and wait at least 10 seconds.
- If DTC is detected, go to DIAGNOSTIC PROCEDURE . If DTC is not detected, system is okay at this time.