Setting Change Function
The settings of the automatic driving positioner system can be changed, using CONSULT-II and the display unit in the center of the instrument panel.
SETTING CHANGE FUNCTION
| Setting item | Content | CONSULT-II (WORK SUPPORT) | Display unit | Factory setting |
|---|---|---|---|---|
| Change seat sliding volume setting | The distance at retain operation can be selected from the following 3 modes. | 40 mm | - | X |
| 80 mm | - | |||
| 150 mm | - | |||
| Change the Entry/Exit seat slide function setting | The seat sliding turnout and return at entry/exit can be selected: ON (operated) - OFF (not operated) | ON | ON: Indicator lamp ON | X |
| OFF | OFF: Indicator lamp OFF | - | ||
| Change the Entry/Exit tilt steering wheel function setting | Lift up and backward steering wheel at entry and exit can be selected: ON (operated) - OFF (not operated) | ON | ON: Indicator lamp ON | X |
| OFF | OFF: Indicator lamp OFF | - | ||
| Reset custom settings | All settings to default. | - | Default: Setting button OFF | - |
It is possible to set sliding driver seat for entry/exit of vehicle by pressing set switch.
SETTING CHANGE OPERATION
| Content | Setting change operation | Indicator LEDs |
|---|---|---|
| The seat sliding turnout and steering wheel up/backward at entry/exit can be operated. | Press the set switch for more than 10 seconds | Blinking twice |
| The seat sliding turnout and steering wheel up/backward at entry/exit can be not operated. | Blinking ones |
NOTE:
After the setting is registered, the new setting is effective, even if the battery is disconnected.