DTC Confirmation Test
- Turn ignition on. Select DATA MONITOR mode with scan tool. Wait at least 10 seconds.
- Press CRUISE switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
- Press ACCEL/RES switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
- Press COAST/SET switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
- Press CANCEL switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE . If 1st trip DTC is not detected, system is okay at this time.