DTC Confirmation Procedure
NOTE:
If DTC confirmation procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
With CONSULT-II
- Turn ignition switch ON.
- Select DATA MONITOR mode with CONSULT-II. See Figure.
- Wait at least 10 seconds.
- Press ON/OFF (MAIN) switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press ACCEL/RESUME switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press COAST/SET switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
- If DTC is detected, Go to DIAGNOSTIC PROCEDURE .
With GST
Follow the procedure with CONSULT-II above.