Procedure For Malfunction A & B

With CONSULT-II 

1. Turn ignition switch ON and wait at least 1 second.
2. Select DATA MONITOR mode with CONSULT-II. See Figure .
3. Shift selector lever to D position and wait at least 3 seconds.
4. Shift selector lever to P position.
5. Turn ignition switch OFF and wait at least 10 seconds.
6. Turn ignition switch ON and wait at least 1 second.
7. Shift selector lever to D position and wait at least 3 seconds.
8. Shift selector lever to P position.
9. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
10. If DTC is detected, go to DIAGNOSTIC PROCEDURE  .

With GST 

Follow the procedure With CONSULT-II above.