DTC Confirmation Procedure
NOTE:
If DTC confirmation procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
Testing condition:
Before performing the following procedure, confirm that battery voltage is more than 10V at idle .
With CONSULT-II
- Turn ignition switch ON.
- Select DATA MONITOR mode with CONSULT-II. See Figure .
- Turn ignition switch OFF, wait at least 10 seconds.
- Turn ignition switch ON.
- If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
With GST
Follow the procedure With CONSULT-II above.