DTC Confirmation Procedure
CAUTION:
Be careful not to overheat engine.
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
WITH CONSULT-II
- Turn ignition switch ON.
- Select DATA MONITOR mode with CONSULT-II. See Figure .
- Check that COOLAN TEMP/S is above 10° C (50° F).
If it is above 10° C (50° F), the test result will be OK.
If it is below 10° C (50° F), go to following step.
- Start engine and run it for 65 minutes at idle speed.
If COOLAN TEMP/S increases to more than 10° C (50° F) within 65 minutes, stop engine because the test result will be OK.
- If DTC is detected, go to DIAGNOSTIC PROCEDURE .
WITH GST
Follow the procedure WITH CONSULT-II above.