Testing Condition:

Before performing the following procedure, confirm that battery voltage is more than 10.5V with ignition switch ON. 

With CONSULT-II 

1. Turn ignition switch ON and select DATA MONITOR mode with CONSULT-II. See Figure
2. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
3. If 1st trip DTC is detected, go to Diagnostic Procedure, DIAGNOSTIC PROCEDURE  .

   If 1st trip DTC is not detected, go to next step.

4. Maintaining engine speed at more than 1,000 rpm for at least 5 seconds.
5. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE 

With GST 

Follow the procedure With CONSULT-II.