Overall Function Check: Notes

Use this procedure to check the overall function of the cooling fan. During this check, a DTC might not be confirmed.

WARNING: Never remove the radiator cap when the engine is hot. Serious burns could be caused by high pressure fluid escaping from the radiator.
Wrap a thick cloth around cap. Carefully remove the cap by turning it a quarter turn to allow built-up pressure to escape.
Then turn the cap all the way off.

WITH CONSULT-II

Check the coolant level in the reservoir tank and radiator. Allow engine to cool before checking coolant level. If the coolant level in the reservoir tank and/or radiator is below the proper range, skip the following steps and go to DIAGNOSTIC PROCEDURE .

Fig 1: Checking Coolant Level
Courtesy of NISSAN MOTOR CO., U.S.A.
Confirm whether customer filled the coolant or not. If customer filled the coolant, skip the following steps and go to DIAGNOSTIC PROCEDURE .
Turn ignition switch ON.
Perform COOLING FAN in ACTIVE TEST mode with CONSULT-II.

Fig 2: Displaying CONSULT-II ACTIVE TEST COOLING FAN Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
If the results are NG, go to DIAGNOSTIC PROCEDURE .