With GST

Lift up drive wheels.
Start engine (TCS switch OFF) and warm it up to normal operating temperature.
Turn ignition switch OFF, wait at least 10 seconds.
Start engine and wait at least 70 seconds.

Fig 1: Checking Overall Function System
Courtesy of NISSAN MOTOR CO., U.S.A.
Set voltmeter probes to ECM terminals 60 (EVAP control system pressure sensor signal) and ground.
Check EVAP control system pressure sensor value at idle speed and note it.
Establish and maintain the following conditions for at least 1 minute.

Fig 2: Identifying EVAP Control System Conditions
Courtesy of NISSAN MOTOR CO., U.S.A.
Verify that EVAP control system pressure sensor value stays 0.1V less than the value at idle speed (measured at step 6) for at least 1 second.
If NG, go to DIAGNOSTIC PROCEDURE .