Active Test Procedure

WARNING: This page is about a different car, the 2003 Infiniti I35. However, it is still accessible from the selected car via links, so may be relevant.

When conducting Active test, vehicle must be stationary.
When ABS warning lamp or SLIP indicator lamp stays on, never conduct Active test.

Turn ignition switch OFF.
Connect CONSULT-II to Data Link Connector.
Start engine.
Touch "START" on CONSULT-II screen.

Fig 1: Displaying CONSULT-II "START" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "ABS".

Fig 2: Displaying "DIAGNOSIS SYSTEM SELECTION" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "ACTIVE TEST".
Select active test item by touching screen.

Fig 3: Displaying "SELECT TEST ITEM" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START".
Carry out the active test by touching screen key.

Fig 4: Displaying "FR RH SOL TEST" Screen
Courtesy of NISSAN MOTOR CO., U.S.A.