Disassembly And Assembly: Disassembly

NOTE: Fix oil pump in vise as the occasion demands.

CAUTION: When retaining drive shaft in a vice, always use copper or aluminum plates between vise and shaft.

Unscrew four rear cover bolts and remove rear cover from body assembly.
Remove gasket from body assembly.
Remove lock pin, cartridge and side plate from body assembly.
Remove pulley from drive shaft assembly.
Remove snap ring from drive shaft assembly and press out it.

Fig 1: Removing Snap Ring From Drive Shaft
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: When removing snap ring, be careful not to damage drive shaft assembly.
Using a screwdriver, remove oil seal for body assembly.

Fig 2: Removing Oil Seal & O-Ring From Body Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove O-ring from body assembly.
Loosen lock nut and remove washer, O-ring, joint then remove connector bolt, O-ring and pull out flow control valve and spring from body assembly.

Fig 3: Displaying Flow Control Valve & Body Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Be careful not to drop and deform the flow control valve.
Remove suction pipe from body assembly.
Remove O-ring for suction pipe.