With Consult-II
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT-II.
- Wait at least 10 seconds.
- Press ON/OFF(MAIN) switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press ACCEL/RESUME switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press COAST/SET switch for at least 10 seconds, then release it and wait at least 10 seconds.
- Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
- If DTC is detected, go to DIAGNOSTIC PROCEDURE .