Inspection Procedure

With CONSULT-II 

1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELF-DIAG RESULTS" mode for "VDC" with CONSULT-II.
3. Touch "ERASE".
4. Turn ignition switch "OFF" and wait at least 10 seconds.
5. Check the self-diagnostic results.
   SELF-DIAGNOSTIC RESULTS
   
   

   Self-diagnosis results
   RAS CIRCUIT

Is above displayed on the self-diagnosis display? 

1. YES : GO TO 2.
2. NO : INSPECTION END

1. Perform RAS control unit self-diagnosis. Repair or replace items indicated, then perform RAS control unit self-diagnosis again. Refer to "SELF-DIAG RESULT MODE ".
2. Perform VDC actuator and electric unit (control unit) self-diagnosis.

OK or NG 

1. OK : INSPECTION END
2. NG : Repair or replace malfunctioning components.